This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
tutorial:torque_administrator_and_operator_commands [2024/03/08 11:17] mjm519 |
tutorial:torque_administrator_and_operator_commands [2024/04/10 14:08] (current) mjm519 [Commands:] |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Torque Common Commands useful for Managers and Operators ====== | ====== Torque Common Commands useful for Managers and Operators ====== | ||
- | Information about command usage can be obtained using the links below or via the man or info commands | + | Information about command usage can be obtained using the links below or via the man or info commands. |
+ | Example: | ||
< | < | ||
info qdel | info qdel | ||
Line 101: | Line 102: | ||
== qhold == | == qhold == | ||
[[http:// | [[http:// | ||
+ | Place non-running job in a state so it will not run. If the job is running, and checkpointing is not enabled the job will terminate. | ||
== qmove == | == qmove == | ||
[[http:// | [[http:// | ||
+ | Move a submitted job to another queue. | ||
== qrun == | == qrun == | ||
[[http:// | [[http:// | ||
+ | Command used to take a non-running job and make it run. When I use this, I look at running jobs and then use the qalter command to specify the node I want the job to run on (based on available resources). | ||
== qstart == | == qstart == | ||
- | |qstat | + | [[https:// |
== qstop == | == qstop == | ||
+ | [[https:// | ||
+ | |||
+ | == qenable == | ||
+ | [[https:// | ||
+ | |||
+ | == qdisable == | ||
+ | [[https:// | ||
+ | |||
+ | == pbsnodes == | ||
+ | [[https:// | ||
+ | This command can be use to enable and disable nodes in the queuing system. | ||
+ | < | ||
+ | manager@polyp1: | ||
+ | polyp5 | ||
+ | polyp14 | ||
+ | polyp15 | ||
+ | polyp30 | ||
+ | |||
+ | Take a node offline: | ||
+ | manager@polyp1: | ||
+ | |||
+ | Put a node back online: | ||
+ | manager@polyp1: | ||
+ | |||
+ | Current Normal Output from pbsnodes -l: | ||
+ | manager@polyp1: | ||
+ | polyp5 | ||
+ | polyp30 | ||
+ | </ | ||
+ | |||